Update virtuals.rst

Note added to Hyper-V section when creating VM.

source/manual/virtuals.rst

@@ -48,9 +48,8 @@ HyperV
 ------
 HyperV Generation 1 and 2 are supported out of the box, no additional drivers
 or tools are needed.
-Secure Boot must not be enabled in the hardware settings for the VM.
 
-.. image:: images/hyper-v_no-enable-sec-boot.png
+* Secure Boot setting must be un-ticked in the Hardware > Security section for the VM.
 
 ------
 KVM
@@ -122,32 +121,28 @@ Common Issues
 Some common issues have been reported for different virtual environments.
 You can find known solutions to these problems below.
 
-If you problem is not listed always try the General tips as mentioned in the
+If your problem is not listed always try the General tips mentioned in the
 article first.
 
-------------------
 
 File copy failed during installation
-------------------------------------
+------------
 This issue is most likely caused by low memory setting. Make sure your virtual
 OPNsense installation has a minimum of 1 GB of RAM.
 
-------------------
 
 Disk Errors on VMware
------------------------
-This issue can be caused by a defective drive. Changing drive mode to IDE has
+------------
+This issue can be caused by a defective drive. Changing the drive mode to IDE has
 been reported to help for certain ESXi versions.
 
-------------------
 
 NAT issues on XenServer
------------------------
+------------
 This issue has been reported to be solved by disabling checksum offloading on both
 OPNsense domU and Vifs.
 
-------------------
 
 Traffic Shaper does not work on VMware
---------------------------------------
+------------
 If you are using vmxnet3 drivers try to switch to E1000.