# Setting up Wi-Fi

!!! tip
    There is nothing more reliable than wired Ethernet, so it's better to use it. Wi-Fi with the steel case (on PiKVM V3 and V4) results in poor performance. But who are we to stop you... :)

The following describes how to setup a Wi-Fi connection.
We recommend to do this while having a display and keyboard
or a serial console connected directly to the Raspberry Pi as you will loose network connectivity once you connect to a Wi-Fi.
Alternatively you can connect to the PiKVM via SSH. The built-in Web Terminal (available through the browser) should also work.

!!! note "Setting up Wi-Fi in the boot config (semi-auto)"
    Check out [this guide](on_boot_config.md) guide. It is mandatory if you're using Zero 2 W board.
    It will useful in most other cases, especially if you have physical access to the memory card.

!!! note
    Devices based on Raspberry Pi Zero 2 W does not support 5GHz Wi-Fi.


## Setting up Wi-Fi manually

1. Make filesystem writable using `rw` command.

2. Create Wi-Fi settings file `/etc/systemd/network/wlan0.network` with following content:

    ```ini
    [Match]
    Name=wlan0

    [Network]
    DHCP=yes
    DNSSEC=no

    [DHCP]
    ClientIdentifier=mac
    RouteMetric=50
    ```

3. Set network ESSID and password:

    ```
    # wpa_passphrase 'MyNetwork' 'P@assw0rd' > /etc/wpa_supplicant/wpa_supplicant-wlan0.conf
    # chmod 640 /etc/wpa_supplicant/wpa_supplicant-wlan0.conf
    ```
    
    !!! note "Using Wi-Fi with hidden ESSID"
        Add option `scan_ssid=1` to `/etc/wpa_supplicant/wpa_supplicant-wlan0.conf`

    !!! note "Using 5GHz Wi-Fi in the USA"
        Add option `country=US` to `/etc/wpa_supplicant/wpa_supplicant-wlan0.conf`

    !!! note "Block 2ghz or 5ghz"
        Add option `bssid=xx:xx:xx:xx:xx:xx` to `/etc/wpa_supplicant/wpa_supplicant-wlan0.conf` within the `network={` block


5. Enable WPA-supplicant service:
   ```
   systemctl enable wpa_supplicant@wlan0.service
   ```

6. Make filesystem read-only again using `ro` command


## Useful console commands

* `iwconfig` - Manipulate the basic wireless parameters.
* `iwlist` - Allow's you to initiate scanning and list frequencies, bit-rates, encryption keys, etc.
* `iwspy` - Displays per node link quality.
* `iwpriv` - Allow's you to manipulate the Wireless Extensions specific to a driver (private).

??? example "Some examples"
    ```
    # iw dev wlan0 scan | egrep "signal:|SSID:" | sed -e "s/\tsignal: //" -e "s/\tSSID: //" | awk '{ORS = (NR % 2 == 0)? "\n" : " "; print}' | sort
    ```
    ```
    # iwlist wlan0 scan | egrep "Cell|ESSID|Signal|Rates"
    ```
    ```
    # iwlist wlan0 scan
    ```
    ```
    # iw wlan0 info
    ```


## Additional resources

* [Arch Linux Wiki for systemd-networkd](https://wiki.archlinux.org/title/systemd-networkd)